-0.9.1 (?/??/2015):
+0.9.2 (9/19/2015):
------------------
+- Added "--keepname" option to install.sh. This option causes install.sh
+ to keep refind_x64.efi named as such rather than rename it as grubx64.efi
+ when using Shim. This option is meaningful only if the --shim option is
+ also used. This option passes the refind_x64.efi filename as an option to
+ Shim, which overrides the default filename of grubx64.efi. A big caveat:
+ Only Shim 0.7 and later supports this feature. (Shim 0.4 also works if a
+ refind_x64.efi is referred to as "\refind_x64.efi" on the command line,
+ but the need for a leading backslash to refer to a file in the same
+ directory as Shim is so confusing and wrong that I cannot in good
+ conscience support it.) I've not seen signed Shim binaries between 0.4
+ and 0.7, so I don't know if any of them might work.
+
+- Implemented a workaround for a bug in Shim 0.8 that prevented
+ authentication of more than one binary. If any filesystem drivers were
+ installed, the first one would be verified, leaving rEFInd unable to
+ launch anything else unless it was signed by a key in the computer's main
+ Secure Boot db list.
+
+0.9.1 (9/13/2015):
+------------------
+
+- When rEFInd identifies the root (/) partition via the Freedesktop.org
+ Discoverable Partitions Specification, it now checks two of the
+ partition's attributes, as per the DPS (see
+ http://www.freedesktop.org/wiki/Specifications/DiscoverablePartitionsSpec/):
+ - The partition's read-only attribute determines whether to pass a "rw"
+ or "ro" option to the kernel.
+ - If the partition's do-not-automount flag is set, rEFInd will not pass
+ it as a "root=" option to the kernel. This flag can be used to remove
+ all but one partition from consideration as a root (/) partition if a
+ system has more than one with the correct type code.
+
+- Improved Freedesktop.org Discoverable Partitions Specification support:
+ Previously, if no refind_linux.conf file was present but an /etc/fstab
+ file was found, rEFInd ignored the Discoverable Partitions Specification
+ filesystem-type codes. This was fine if /etc/fstab contained a valid "/"
+ filesystem specification, but if that was absent, the result was no
+ "root=" specification being present. Under these circumstances
+ (refind_linux.conf absent, /etc/fstab present but lacking a "/" entry),
+ rEFInd now tries to identify a device to specify as "root=" via the
+ Discoverable Partitions Specification.
+
- Fixed bug that caused "Found match!" and a prompt to press a key to
continue to be printed if any partition used the Freedesktop.org
Discoverable Partitions Specification root-partition GUID. (This