core: infrastructure for alternate sampling rate

[pulseaudio] / man / pulse-daemon.conf.5.xml.in

diff --git a/man/pulse-daemon.conf.5.xml.in b/man/pulse-daemon.conf.5.xml.in
index 6fcdd0ec02fece763ec1cf2db99b22c51ddf937b..33ea79204d0f40df09e7f8e7a870ac9c17187800 100644 (file)
--- a/man/pulse-daemon.conf.5.xml.in
+++ b/man/pulse-daemon.conf.5.xml.in
@@ -414,6 +414,15 @@ USA.
       <p><opt>default-channel-map</opt> The default channel map.</p>
     </option>
 
+    <option>
+      <p><opt>alternate-sample-rate</opt> The alternate sample
+      frequency. Sinks and sources will use either the
+      default-rate-rate value or this alternate value, typically 44.1
+      or 48kHz. Switching between default and alternate values is
+      enabled only when the sinks/sources are suspended. This option
+      is ignored in passthrough mode where the stream rate will be used.</p>
+    </option>
+
   </section>
 
   <section name="Default Fragment Settings">
@@ -438,7 +447,7 @@ USA.
 
   </section>
 
-  <section name="Default Sync Volume Settings">
+  <section name="Default Deferred Volume Settings">
 
     <p>With the flat volume feature enabled, the sink HW volume is set
     to the same level as the highest volume input stream. Any other streams
@@ -448,20 +457,20 @@ USA.
     cause the resulting output sound to be momentarily too loud or too soft.
     So to ensure SW and HW volumes are applied concurrently without any
     glitches, their application needs to be synchronized. The sink
-    implementation needs to support synchronized volumes. The following
+    implementation needs to support deferred volumes. The following
     parameters can be used to refine the process.</p>
 
     <option>
-      <p><opt>enable-sync-volume=</opt> Enable sync volume for the sinks that
+      <p><opt>enable-deferred-volume=</opt> Enable deferred volume for the sinks that
       support it. This feature is enabled by default.</p>
     </option>
     <option>
-      <p><opt>sync-volume-safety-margin-usec=</opt> The amount of time (in
+      <p><opt>deferred-volume-safety-margin-usec=</opt> The amount of time (in
       usec) by which the HW volume increases are delayed and HW volume
       decreases are advanced. Defaults to 8000 usec.</p>
     </option>
     <option>
-      <p><opt>sync-volume-extra-delay-usec=</opt> The amount of time (in usec)
+      <p><opt>deferred-volume-extra-delay-usec=</opt> The amount of time (in usec)
       by which HW volume changes are delayed. Negative values are also allowed.
       Defaults to 0.</p>
     </option>